Program CGDI ELV Emulator Step by Step

How-to: program CGDI ELV Emulator with CGDI Prog MB Benz key programmer step by step.
cgdi-elv-emulator
Procedure:
program-cgdi-elv-emulator-1
In CGDI MB Software, choose Compute Password option->Collect Data-> The 1 generation key
We start with insert key in EIS
program-cgdi-elv-emulator-2
Remove key and insert it in CGDI IR shown as picture
We have to wait till its is 100% loaded without touching the key
program-cgdi-elv-emulator-3
Remove key from CGDI MB and insert it back in EIS
program-cgdi-elv-emulator-4
Pull key out of EIS
program-cgdi-elv-emulator-5
Reinsert key into EIS
program-cgdi-elv-emulator-6
Pull key out and count to 5 seconds then insert it back again, then press OK
program-cgdi-elv-emulator-7
Insert key into CGDI IR
program-cgdi-elv-emulator-8
Save generated data, choose wherever you want to save data
program-cgdi-elv-emulator-10
Then we can upload the data to server
program-cgdi-elv-emulator-11
Press Query Result and wait till the password is calculated
program-cgdi-elv-emulator-12
Calculate pass success. Press Copy button
program-cgdi-elv-emulator-13
We choose EIS now and press Read EIS Data
Then paste the copied password previously
program-cgdi-elv-emulator-14
Save EIS data
program-cgdi-elv-emulator-15
Now we go to ELV option
Choose Simulator
Load EIS data saved previously
program-cgdi-elv-emulator-16
Press Write
program-cgdi-elv-emulator-17
It will give you message Connect the yellow Kline from the OBD cable to the CGDI ELV emulator
program-cgdi-elv-emulator-18
Writing success, now you can use the emulator
Turn on ignition switch to activate it.
Done.

Leave a Reply

Your email address will not be published. Required fields are marked *