Tag Archives: SBB

How to use SBB to Register Key for Nissan Note 2007

This is a Nissan Note 2007  (automatic, right wheel, Intelligent Key). There is a working key, customer need to add chip key startup.

nissan-note-key-programming-1

nissan-note-key-programming-2

(Note: The tutorial is translated from Russian, for educational purpose only)

 

Diagnostic device ABRITES Vehicle Diagnostic Interface , when selecting (Nissan Note 2006+) requires a 12-digit PIN code, which is presumably considered for label located behind the glove compartment (glove box).

nissan-note-key-programming-3

But the car has a sticker, so the chip should be registered with the device SBB Key Programmer.

nissan-note-key-programming-4

How to calculate PIN code for registration key / chip in the car?

PIN will be assumed by the label BCM, with the help of the program AD600 Code Wizard Pro (Demo the Version) , which can be downloaded at this  link. Or by hand-held Nissan Pin code reader NSPC001.

nissan-note-key-programming-5

To perform this procedure, you’ll need:

  • Net HITAG 2 transponder – PCF7936.
  • Wires (jumpers), for supplying power to the ignition contacts.

How to register the vehicle key / chip on Nissan Note using SBB Key Programmer?

1. Insert the device connector SBB v46.02 in OBDII vehicle.

2. The instrument select NISSAN JAPANthe MICRA MARCH 00-Gasoline

nissan-note-key-programming-6

nissan-note-key-programming-7

nissan-note-key-programming-8

3. Then Insert a key and turn on the console – Insert the key into the lock, and turn the ignition switch on.

nissan-note-key-programming-9

4. The instrument choose NATS 5the PROG. NEW KEYS.

nissan-note-key-programming-10

nissan-note-key-programming-11

5. Without the PIN CODE you CAN not program new keys – Without a PIN, you can not program the new keys.

nissan-note-key-programming-12

6. Enter the 4-digit PIN number, counted on the label BCM.

nissan-note-key-programming-13

7. Insert keys to be programmed in sequence and turn them on and off for 5 sec respectively. In the end start the engine for some sec. Press any key … Press – Insert the key to be programmed in sequence, one after the other, on and off the ignition for 5 seconds. After the end of the programming start the engine.

nissan-note-key-programming-14

8. Once the button is pressed all quickly, without errors:

  • LED standard signaling, in the right corner at the windshield starts to blink.
  • Turning off the ignition, take out a sting from the ignition.
  • We put a thorn in the ignition, turn the ignition.
  • Turning off the ignition, take out a sting from the ignition.
  • Place the transponder antenna on the ignition.
  • Provide the + 12V on wire and KEY IN KEY PUSH (red-blue and red and white, respectively).
  • Turning on the ignition by supply of + 12V to the corresponding contacts ignition.
  • Turn off the ignition.
  • We start the engine.

http://www.key-programmer.org/2017/07/18/register-key-for-nissan-note-2007-by-sbb/