SKP1000 Key programmer read Fiat Siena ECU ISO Code by OBD

Older Fiat Siena or Palio required to remove ECU or write key to start to make new key. Here is revolutionary solution on getting Fiat ECU ISO code and programming special ID48 chip key by using SKP1000 key programmer via OBD directly. SKP1000 tablet=SKP900+ Lonsdor CI600 Plus. fiat-siena
Instruction:

Step 1: Read ECU ISO code (security pin code)

Select car brand: Fiat

select-read-iso-code
Select read iso code
select-immo-system
Select Electronic immobilizer system
read-iso-code
Select read iso code
disconnect-battery
After read ecu iso code success, disconnect the battery.
If read iso code failed,please disconnect the battery and try again
(Anyway, disconnect the battery)
read-car-info
SKP-1000 read Fiat info and fiat iso code
Press YES to continue
working-key
Check if you have a working key
If yes, Press YES button to continue
turn-ignition-on
Turn ignition to ON position
turn-ignition-off
Turn ignition to OFF position
turn-ignition-on
Turn Ignition ON
read-iso-code-success
Read iso code success
enter-iso-code
manually enter 5-digit iso code
skp1000-read-immo-data
SKP1000 will read the immo data, please write download the numbers (will be used to generate chip)

Step 2. Generate Fiat special ID48 chip

generate-special-chip

Select Fiat common chip to generate special chip

generate-fiat-id48-special-dealer-key
select generate Fiat ID48 special dealer key
immo-adpater
Insert the immo adapter into the SKP1000 car key programmer, select Special function and select Generate Fiat chip
insert-id48-chip
Insert the blank ID48 chip into the coil of the adapter
enter-immo-code
Manually enter 24-digit immo code (read previously)
immo-code-marked-red
Enter 24-digit code marked red
confirm-immo-code
confirm the entered digits

Step 3: Program chip key

select-program-key

select Program key

select-siena-key-programming
Select Siena key programming,
SKP1000 will also program key for Fiat 500, Boyue,Palio,Leap,viaggio and Perla
select-immo-system
Select Electronic immobilizer system
select-obdii-connector
Select OBDII connector
turn ignition to ON position
select-program-keys
select Program key
Key without programming cannot be used
Press YES to continue
enter-iso-code
enter 5 digits iso code
confirm
program-more-key
continue to program more keys
Press YES to continue
change-next-key
please change next key
program-success
If the dashboard indicator goes off, program success.
Disconnect SKP 1000 and test the new key.
0

Leave a Reply

Your email address will not be published. Required fields are marked *