Ford Focus 2008 PCM Reprogramming via Ford IDS

This how-to guide is aimed to help Ford PCM power-train control module programming with a VXDIAG VCX NANO for Ford– a redesign of the Ford VCM2 unit.
If you change the new original ECU, then can directly to program. If you want to use used ECU to change the broken ECU, first use this software to work on the car with broken ECU, then choose the option, see the prompt then change the used ECU for programming.
Need 14v when you do programming!!
Put battery charger on battery and retry.
This is a new Focus PCM to be programmed by Ford IDS.
Vehicle specification:
Focus 2008
DURATEC-HE/I4
ford-info
Module programming
module-programming
Programmable module installation: PCM
pcm-programming
Module programming notice:
You are about to program a procedure using the module programming application you purchased. The reason for this module programming may pertain to a Field Service Action that has been recommended by the manufacturer for the customer’s vehicle. In many instances, such services are provided free of charge to the customer when that service is provided by the manufacturer’s dealer. As part of the terms and conditions of your use of this application, you are obligated to inform the customer of this fact. Prior to performing any service on their vehicle, you must allow them the opportunity ti check with their local dealer to determine if their vehicle is in fact eligible for the repair free of charge. The manufacturer will not reimburse a customer for such services if not performed by a dealer
vehicle-info
Establish an internet connection
internet-connection
Set ignition switch to OFF
ignition-off
During the module programming, this module goes through a VIN verification process.
This process compares the VIN in this module with the VIN in other modules on the vehicle. You may see the VIN verification screen more than once depending upon your response to the question.
vin-verification
VIN is correct?
confirm-vin
Install a new module in vehicle
install-new-module
Do not start a reprogramming section with a low battery in the vehicle and/or programming tool.
The fuel pump and the engine cooling fans may run during the following procedure
If you are programming a 6.0L diesel, the FICM relay must be removed before programming
ficm-relay
Set ignition switch to ON
ignition-on
Erase procedure in process
erase-procedure
PCM reprogramming
pcm-reprogramming
Set ignition switch to OFF
ignition-off
in-progress
Set ignition switch to ON
switch-to-on
Set ignition switch to OFF
switch-off
Calibration has been loaded and checked
calibration-loaded
If you programmed 6.0L diesel, please reinstall the FICM relay
reinstall-ficm-relay
If required, obtain a PCM reprogramming label and complete as the screen displays
pcm-programming
Start engine
start-engine
Set ignition switch to OFF
switch-off
Set ignition switch to ON
switch-on
Clearing fault codes
clear-fault-code
Set ignition switch to OFF
switch-to-off
Run programmable module installation to correct the VIN
Note: the modules listed may not be installed on the vehicle. Verify that the modules are installed before performing diagnostics
programming-success
VXDIAG VCX NANO for Ford programmed the PCM module successfully.
0

Leave a Reply

Your email address will not be published. Required fields are marked *