How to clone TPMS sensors via Autel MaxiTPMS TS601

There are 3 ways to clone a set of TMP sensors using Autel MaxiTPMS TS601 TMPS service tool scanner and a MX-sensor.

 

Method 1:

using TS601 to activate the broken OE sensor

autel-ts601-test-tmps-for-porsche-cayenne-2010-15

directly to retrieve the sensor id

autel-ts601-test-tmps-for-porsche-cayenne-2010-16

then program to the MX-sensor

autel-ts601-test-tmps-for-porsche-cayenne-2010-17

Method 2:

it’s used when the original sensor is not transmitting any more

autel-ts601-test-tmps-for-porsche-cayenne-2010-18

in this case, connect the MaxiTPMSTS601 scan tool to the vehicle by the TS601 OBDII cable

autel-ts601-test-tmps-for-porsche-cayenne-2010-19

autel-ts601-test-tmps-for-porsche-cayenne-2010-20

and retrieve the sensor id from the car system

autel-ts601-test-tmps-for-porsche-cayenne-2010-21

autel-ts601-test-tmps-for-porsche-cayenne-2010-22

unplug the TS601 from the car when learning is successful

insert the MX-sensor and program the copied id to the sensor to finish coding

autel-ts601-test-tmps-for-porsche-cayenne-2010-23

Method 3:

it’s to manually input the original sensor id to Autel TS601

autel-ts601-test-tmps-for-porsche-cayenne-2010-24

autel-ts601-test-tmps-for-porsche-cayenne-2010-25

then program it to the MX-sensor

autel-ts601-test-tmps-for-porsche-cayenne-2010-26

since the new sensors are programmed with the same original sensor id, install it in the same position on the wheel

autel-ts601-test-tmps-for-porsche-cayenne-2010-27

no TPMS relearn procedure is needed after replacement

 

Enjoy!

0

Leave a Reply

Your email address will not be published. Required fields are marked *