Fgtech Galletto 2 EU cannot write EDC17 solution

A customer shared his problem and solution when read and write EDC17 with the FGTech Galletto 2 master ecu programmer.
“I tried to read in boot mode the ECU EDC17 C41 – TC1797 from bmw 116 F20 bosch nr. 0281030980,
with FGTech Galletto 2 EU and when click in “ECU Data” button appear this info from ecu :
“Infineon Tricore TC1797
CPU-ID=0000910100001820
Internal Flash ID = 0053C001
Internal Flash 4096Kb Protected
OTP Protect: 0x14000 — 0x17FFF
Internal Flash2 ID = 0055C001
Internal Flash 4096Kb Protected
EEprom 64Kb Protected
READING ECU
Start reading…ERROR UNLOCK READ – TRY TOOL TRICORE PASSWORD TPROT V08 ”
I tried to use the TRICORE PASSWORD TPROT V08 from menu without boot mode but i can’t.
Says the message fgtech error
Then how can I read / write this ecu for tuning with my tool FGTech Galletto EU version?
Now obd365.com engineer give you an answer:
Forget about F series with FGTECH, you can’t do it.
Including KTAG, it can only on Exx series BMW, NOT Fxx.
So far, the ideal ECU programmer is DS17 Infineon Tricore Boot Reader, a part of senior engineers have proved it can worked out EDC17, while KESS V2 can’t.
General introduction about DS17 ECU Programmer(DS17 Infineon Tricore Boot Reader).
DS17 Infineon Tricore Boot Reader is an updated version for BDM100, it takes direct access on processor and EPROM memory of the ECU over a dedicated port like the BDM system. DS17 supports EDC17,  MED17,  ME17,  MEV17,  MEVD17,  PCF2.1,  SD13,  SD14,  SD16,  SID208,  SID807.
0

Leave a Reply

Your email address will not be published. Required fields are marked *